HOME | About us | Overview of IAQ | Who uses our services | Testimony | Our Test Equipment

Inspection Services and Costs | Insurance & VCAT Reports | Environmental & Energy Auditors | Indoor Air Quality Testing


FUNGAL GROWTH - CALL 1300 382 826

Internal fungal growth is a symptom of moisture trapped in the built environment. Generally speaking it is caused by water ingress from a damaged pipe, a leaking window or some other form of liquid moisture entering the building envelope. As such, the diasgnosing of the cause of fungal growth is the same as the causes of mould or condensation - unwbnted and trapped moisture.

The fungal growth is caused by fungal spores which are dormant but present in the building envelope meeting up with moisture and a potential food source, being building materials.


SOURCES OF MOISTURE IN THE BUILT ENVIRONMENT

 

1. Flood through equipment breakdown, storm and rising water

Water from these sources can be classified as either Category 1 (clean), Category 2 (general contamination) or Category 3 (sewerage) and we have the equipment and knowledge to quickly remove flood water from any dwelling. Speed is of the essence in attempting to avoid the negative consequences of water in the dwelling as if left, it can lead to mould, distorted timbers, condensation and long term damage to furniture and general belongings.

 

2. Moisture (visible and hidden) caused by a lack of ventilation

More difficult to reverse, often the symptoms of a lack of ventilation - rising damp, mould, mildew and condensation - have taken years to manifest themselves and can take several months to reverse unless radical action is taken.


MOISTURE DETECTION

 

The trick to any water damage salvage operation is fast action - and identifying all moisture laden areas of the dwelling, including invisible moisture, is paramount to the erradication of it.

Our moisture identification equipment and techniques will quickly and efficiently identify all moisture in the building and the entry points. This is achieved via infra red inspection technology which identifies temperature differences deep into building materials, concrete inspection metres, plaster and timber inspection metres and atmospheric moistue identification metres.


MOISTURE ERRADICATION

 

Step 1 - Identify the source of water breach and stem the moisture source

The first step in any moisture reversal or erradication process is to stem the source of the moisture. If this is an' event' type of invasion (flood, damaged rains), then the first step is to ensure that the event has been repaired. The source of the water breach must first be identified and our impressive array of moisture detection equipment can quickly identify all water breaches even if not immediately visible.


Step 2 - Identify moisture contamination

Our sophisticated equipment can quickly identify the presence of all moisture and water contamination in plaster, concrete and all porous materials, as well as atmospheric moisture distortions.


Step 2 - Dry the building

Our sophisticated equipment can quickly identify the presence of all moisture and water contamination in plaster, concrete and all porous materials, as well as atmospheric moisture distortions.


Step 3 - Remove and/or reverse the symptoms of moisture

Once we have stabilised the situation, we then clean up all mould affected areas of the dwelling, and dry out the building using dehumidifiers, airmovers and large gas fired heaters.


Step 4 - Increase the ventilation

If it is a lack of ventilation (as opposed to an event) then the first step is to increase the ventilation, typically through a combination of forced or mechanical ventilation and adding passive vents. Often, if the moisture in the subfloor (moisture is typically found in the subfloor of the dwelling) is severe, we adopt a radical approach to its reversal and will dry out the subfloor before installing a long term mechanical ventilation system.

Environmental Audits | Energy Auditors | Industrial Air Quality Testing | Environmental Testing Services | Residential Air Quality Testing
Copyright 2014 © Enviromaster | Address: PO Box 120, Ivanhoe 3079 | Phone: 1300 382 826 | Email: quote@enviromaster.com.au